Panasonic Panafax UF-885 User Manual page 158

Troubleshooting
Mode
Print Copy Quality
Communication
No Unit Operation
156
Symptom
Vertical lines printing Print out a Journal report (e.g. FUNCTION, 6, 1 , SET and 1)
on the received and check quality to make sure whether your machine has
document trouble.
If Journal report quality is OK, your machine has no problem,
report to the sending party that they have a problem.
If copy is NG, replace the Toner Cartridge.
Fuzzy print 1. Make sure you are using the correct paper for the best
2. Try reversing the recording paper to the other side.
Missing dots or lines/ 1. Make sure you are using the correct paper for the best
inconsistent darkness
within print 2. Replace the Toner Cartridge.
Fading print Your Toner Cartridge may be running out of toner. Replace
the Toner Cartridge.
Faint print You may need to choose a different paper for the best possible
print quality.
Intermittent partial or Your Optional Page Memory setting value is set larger than the
total black print. actual DRAM Memory Card installed. Make sure Fax
Parameter 60 is set to the DRAM Memory Card Size.
No dial tone 1. Check the connection of the telephone line.
2. Check the telephone line.
No auto answer 1. Check the connection of the telephone line.
2. Check the Reception mode setting.
3. If the Fax Parameter No. 13 (AUTO JOURNAL PRINT) is
Cannot transmit or An information code will be shown on the display. Refer to the
receive information code table to find out the trouble.
No unit operation To reset the machine, turn-off the Power Switch for a few
seconds then turn it on again.
Cause / Action
possible print quality.
possible print quality.
set to "Valid" (default setting) and the machine is printing
the received document from memory, which also happens
to be the 100th transaction, the machine will not auto
answer until the Transaction Journal completes printing.
page
143
16
172
172
16
16
172
38
167
167
60
157
21