Panasonic Panafax UF-885 User Manual page 38

Customizing Your Machine
No. Parameter
24 PRINT REDUCTION
25 REDUCTION RATIO
26 POLLING PASSWORD
27 POLLED FILE SAVE
28 STAMP AT MEM. XMT
31 INCOMPLETE FILE
SAVE
32 COPY REDUCTION
33 XMT REDUCTION
34 ENERGY SAVER MODE
Continued on the next page.
36
Setting
Setting
Number
1 Fixed Selecting print reduction mode.
Fixed: Reduce received document according to setting of
*2 Auto
Auto: Reduce received document according to the length of
70 70% Selecting fixed print reduction ratio from 70% to 100%. This
parameter functions only when fixed print reduction is selected on
---- ----
Fax Parameter No. 24.
100 100%
(----) Setting a 4-digit password for secured polling. (See page 68)
*1 Invalid Selecting whether the machine retains the polled document in
memory even after the document is polled once.
2 Valid
1 Invalid Selecting whether the machine stamps the original documents
when storing the documents into memory.
*2 Valid
(depending on the Stamp setting on the Control Panel)
*1 Invalid Selecting whether the machine retains the document in memory if
the document is not successfully transmitted.
2 Valid
1 Manual Selecting whether the machine performs the copy reduction ratio
automatically or manually.
*2 Auto
Manual : The machine will prompt you for the Zoom ratio (100% to
Auto
1 Invalid Selecting whether the machine performs reduction when the
transmitting document is wider than the recording paper used at
*2 Valid
the receiving machine.
To reduce the power consumption in standby, select either Energy-
Saver or Sleep mode and specify the Delay Time (1 to 120
minutes) for the machine to enter into the selected mode.
1 Off
The Delay Timer setting is only available in the Energy-Saver or
Sleep Modes.
Off :
2 Energy-Saver Energy-Saver Mode: Saves energy by consuming less power than
Sleep Mode:
*3 Sleep
Comments
Parameter No. 25.
received documents.
70%) when making copies.
: The machine will automatically determine the reduction
ratio according to the length of the original document.
The unit will remain in standby mode and
consume more energy than when in Energy-
Saver or Sleep modes.
when in standby mode by turning off the fuser
unit after the specified time.
This is the lowest power state that the
machine enters after the specified time
without actually turning off. (Sleep Mode is
not available when the optional Parallel Port
Interface Kit, PDL Printer Driver Kit or G3
Communication Port Kit is installed)