Table of Contents
Advertisement
Operating from a remote
The following operations can be performed from a remote location using a touch tone telephone.
Program the remote operation ID (feature #11 on page 62) and set the unit to TAD/FAX
mode before going out (p. 50).
Dial key
Remote command
Skips the greeting message
0
1
Repeats a message
2
Skips a message
4
New message playback
5
All message playback
6
Room monitor
7
Re-records a greeting message
Stops re-recording of a greeting
9
message
Remote operation card
Please cut out and carry this card for assistance when using the remote operation.
1. Call your unit.
2. Enter the remote operation ID
message.
The new messages will be
played automatically.
If there are no new
messages, wait for 4
seconds. All the messages
will be played back.
3. Press the remote command
key(s) within 10 seconds (see
the reverse side).
Page
Answering Device
Remote Operation
during the greeting
Remote Operation
location!
Dial key
57
Erases a specific message
4
56
Erases all messages
5
56
Changes to TEL mode
8 0
56
Turns ON message transfer
8 1
56
Turns OFF message transfer
8 2
57
Turns ON pager call
8 3
57
57
Turns OFF pager call
8 4
Notice of Remote Operation
The remote operation is
available only from a touch tone
telephone when the unit is in
TAD/FAX mode.
When the unit is in TEL mode,
call your unit and wait for 10
rings. The answering device will
temporarily answer the line.
Enter the remote operation ID
during the greeting message.
The unit will switch to TAD/FAX
mode.
When you press a key, press
firmly.
To send a document, press
. When a fax tone is
9
heard, start transmission.
Remote command
Page
57
57
57
57
57
57
57
55
Advertisement
Table of Contents
