Panasonic Toughbook CF-Y4HWPZZBM Operating Instructions Manual page 49

Panasonic toughbook cf-y4hwpzzbm: user guide
Table of Contents

Advertisement

Problems with Battery
The battery indicator is lights red
The battery indicator is blinking
The battery indicator is flashing
Problems with Onscreen Reference Manual
The Reference Manual is not dis-
played
Reinstalling B's Recorder/B's CLiP
When reinstalling, you will be asked
for a serial number
Can't write to the disk, even though
a disk formatted with B's CLiP has
been set
Problems with Expanding Memory
You do not know the available RAM
module
To check if the additional RAM mod-
ule has been installed successfully
The battery level is very low (the charge is approx. 9% or less).
Connect the AC adaptor. You can use the computer when the indicator light
is orange. If you do not have an AC adaptor, save your data and power off
your computer. After replacing the battery pack with a fully charged one,
turn your computer on again.
If blinking red:
Quickly save your data and power off your computer. Remove the battery
pack and disconnect the AC adaptor, then connect them again. If the prob-
lem persists, contact your technical support office. The battery pack or
charging circuit may be defective.
If blinking orange:
• Battery cannot be recharged temporarily because the internal tempera-
ture of the battery pack is outside the acceptable temperature range for
recharging. Your computer can be used normally in this state. Once the
range requirement is satisfied, charging begins automatically.
• Software applications and peripheral devices (USB devices, etc.) are con-
suming too much power. Exit the software applications currently running.
Once the range requirement is satisfied, charging begins automatically.
The battery is recharging.
If [Battery Charging Indicator] in [Main] menu of the Setup Utility is set to
[Flashing], the indicator will alternately become lighter and darker.
Is Adobe Reader installed?
If you have uninstalled Adobe Reader, install using the following proce-
dures.
A Log on to Windows with the administrator authority.
B Click [start] - [Run], input [c:\util\reader\AdbeRdr70_enu_full.exe],
then click [OK].
Install Adobe Reader by following the instructions on the screen.
C Update Adobe Reader to its latest version.
If your computer is connected to the Internet, start up Adobe
Reader and click [Help] - [Check for updates now...].
Input the following serial number.
B's Recorder:
B's CLiP:
Did you open the disk cover forcefully in standby mode to set the disk?
If you did, slide the drive power/open switch to the left to turn the DVD-ROM
& CD-R/RW drive power off, and then turn the power on again.
page 62
If the installation is successful, the main memory and total RAM module
size appears in the [Information] menu of the Setup Utility.
If the RAM module is not confirmed:
• Turn the computer off and reinsert the RAM module.
• Confirm the recommended specifications.
Regarding the RAM module, refer to "Expanding Memory" or "Specifica-
tions."
49

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Cf-y4 - batt forCf-y4 series

Table of Contents