Factory Reset; Help/Setup Alerts - Toro EVOLUTION Series Quick Start Manual

Factory Reset

Select this function to reset the controller to the factory default parameters. Schedule B, C and Auxiliary will be disabled and all
and all of their parameters will be cleared or set to OFF. Schedule A will be set with a WEEKDAY schedule with all 7 days active.
It will have one start time set to OFF and all zone runtimes set to OFF.
Help/Setup
Alerts
The EVOLUTION controller always checks the system for proper function and it will provide feedback if it detects any system abnormality. The Alerts menu
®
allows you to view and clear detected system faults.
Alert Listings
Freeze Hold EVOLUTION
®
or Weather sensor is connected).
Short EVOLUTION detected a short in the zone.
®
Overcurrent EVOLUTION detected an over current in the zone. Over current occurs when a terminal or combinations of terminals exceeded the
®
recommended current draw rating.
Low Battery EVOLUTION
®
Factory Reset is performed or the newly installed battery runs low again.
Low A/C Power EVOLUTION
Factory Reset EVOLUTION
Communication Error EVOLUTION
Clearing an Alert
You can clear Alerts using the CLEAR ALL command to erase them all, or you can clear each alert separately.
Step 1 – Press HELP/SETUP.
Step 2 – Use the Up
Step 3 – Use the Up
Step 4 – Use the Up
18
detected temperatures below the set FREEZE OFF temperature when the controller tried to irrigate. (Only available if Rain/Freeze
detected no battery installed or the battery's power is low. Once the Low Battery alert is cleared, it will not display again unless a
detected low or no A/C power.
®
encountered an error that required the system to reset to the factory defaults.
®
encountered a communication error with the output zones.
®
or Down arrows to select the Alerts. Press SELECT
or Down arrows to select individual alerts or CLEAR ALL. Press SELECT
or Down arrows to confirm (Yes) or cancel (No). Press SELECT
.
.
.
FACTORY RESET
RESET TO FACTORY
DEFAULTS? YES
ALERTS
CLEAR ALL
LOW BATTERY