Table of Contents
Advertisement
RS485 Setting
The 4-bit DIP switch in used for
RS485 termination.
Switch
position
BP 2
ON ON ON
Switch
position
OFF OFF OFF
Notes:
• Defaults are marked with
• BP stands for Bit Position.
• Daisy chain connection is not available for
Full Duplex. (Only for Panasonic's system
controllers)
3. Assemble the Camera
Reverse the disassembly procedure. Take
care not to cut any cables.
Precaution
Be sure to select a ceiling board strong
enough to support 4 times the total weight of
the camera.
a. Sideway Cable Exit
Prepare a cutout in the diecast case and
decoration cover as shown in the following
figures.
Cutout in Diecast Case
Cutout in Decoration Cover
46
SW 2
ON
1
2
BP 1
Function
ON
Termination ON
OFF
Termination OFF
BP 3 BP 4
Function
Half duplex (2 line)
Full duplex (4 line)
.
*
Note: Remove sharp edges to protect the
cables.
3
4
*
b. Top Cable Exit
Prepare a hole in the ceiling board to run the
cables.
*
1. Mark the mounting holes on the ceiling,
using the removed camera mounting base
as a template.
2. Fix the camera mounting base to the ceiling
with four screws (not provided, M4).
Marking
Advertisement
Table of Contents
