Table of Contents
Advertisement
Synchronization (SYNC)
1. Display SET UP on the monitor screen.
If necessary, refer to Setup Menu Display on page 16 for details
on displaying the SET UP menu on the monitor screen.
2. Move the cursor to SYNC and select line-lock (LL) or internal (INT)
by using the joystick.
The factory default setting is INT.
Important Notices:
1. The priority of SYNC modes is as follows:
1. Multiplexed vertical drive (VD2) (highest priority)
2. Line-lock (LL)
3. Internal sync (INT) (lowest priority)
2. To use internal sync, select INT.
3. Whenever the vertical drive pulse (VD2) is supplied to the cam-
era, the camera sync mode is automatically switched to the multi-
plexed vertical drive (VD2) regardless which sync mode is select-
ed.
Line-lock Sync Mode (LL)
1. Display SET UP on the monitor screen.
(Refer to Setup Menu Display on page 16 for details on displaying
the SET UP menu on the monitor screen.)
2. Move the cursor to SYNC and select LL by using the joystick. LL
sync mode is not available when the multiplexed vertical drive
(VD2) pulse is supplied.
3. After selecting LL, press the CAM (SET) key.
The SYNC menu appears on the monitor screen.
4. Supply the video output signal of the camera to be adjusted and
the reference camera video output signal to a dual-trace oscillo-
scope.
5. Set the dual-trace oscilloscope to the vertical rate and expand the
vertical sync portion on the oscilloscope.
6. Move the cursor to COARSE by using the joystick.
33
Camera setting menu
** SET UP **
CAMERA ID
ON
ALC/MANUAL
ALC
SHUTTER
OFF
AGC
ON(MID)
SYNC
INT
WHITE BAL
ATW
AF MODE
MANUAL S
EL-ZOOM
ON
IMAGE HOLD
OFF
RET
SPECIAL
Camera setting menu
** SET UP **
CAMERA ID
ON
ALC/MANUAL
ALC
SHUTTER
OFF
AGC
ON(MID)
SYNC
LL
WHITE BAL
ATW
AF MODE
MANUAL S
EL-ZOOM
ON
IMAGE HOLD
OFF
RET
SPECIAL
SYNC menu
** SYNC **
V PHASE
COARSE
1(1--16)
FINE
•|•••••••
-
+
RET
Advertisement
Table of Contents
