Table of Contents
Advertisement
CITY SERIES 60
12. Loosen 8 screws in locations shown below (4 at front and 4 at rear)—
slide burner to the left away from the orifice and lift out.
tooltip
tooltip
13. Remove burner orifice with a 3/8" wrench. Use another wrench to hold
on to the elbow behind the orifice. Discard orifice. Reinstall new burner
orifice LPG stamped #50 and tighten.
tooltip
14. Remove pilot retainer clip with pliers and pull off the pilot cap to expose
the pilot orifice.
Pilot retainer clip
920-225
Single-sided model shown
Burner screw locations
Single-sided model shown
Slide burner to the left and lift out
Single-sided model shown
Burner Orifice Location
15. Unscrew the pilot orifice with the Allen key; then replace with the LPG
pilot orifice and the pilot cap, provided in the kit.
16. Reinstall pilot cap and pilot retainer clip.
17. Prior to installing burner—adjust aerations settings - to 3/8" for LP. Re-
install burner (see Step 11).
18. Make sure aeration cap tab is inserted into the slot on the bracket. Adjust
aeration handle if necessary.
Aeration cap tab
19. Reverse steps 1 to 11.
20. Ensure the pilot lilght is in the correct orientation to the burner. Recon-
nect the gas and electrical supplies. Start the appliance (see section
on Lighting Instructions). Ensure that pilot and burner ignition are com-
pleted without delay. Check inlet and outlet pressures at full load. With
a soapy solution, leak test the entire system. Verify correct flame and
pilot appearance.
21. See Gas Pipe Pressure Testing in manual.
Min. Supply Pressure
Manifold Pressure - High
Manifold Pressure - Low
Orifice Size
Maximum Input
Minimum Input
Altitude
Installer Notice:
These instructions must be left
with the appliance
2
Slot on bracket
aeration
handle
City Series
LP SYSTEM DATA
11" WC (2.73kpa)
10.5" WC (2.62 kpa)
2.9" WC (0.72 kpa)
#50 DMS
36,000 Btu/h (10.54 kW)
19,500 Btu/h (5.71 kW)
0-4500 ft (0-1372m)
.
City Series CV60E-1 |
installation
06.09.20
75
Advertisement
Table of Contents
