Prescribe Commands; Printer Driver; Process Unit; Ram Disk - Kyocera FS FS-1020D Operation Manual

MP tray
This is an abbreviation for Multi-Purpose tray.
The MP tray is used instead of the cassette when
printing on envelopes, postcards, transparency
sheets, and labels.
Offline
The printer can receive data, but cannot print.
Turn the printer online if you want to print.
Online
The printer can output received data.
Operator panel
This is located on the top right side of the printer.
The panel consists of four indicators and two
keys. The four indicators light, flash, and go off
in combination to indicate the printer's status.
Press the keys when you want to switch the
printer between online and offline status, or to
cancel printing.
Outline font
With outline fonts, characters outlines are
represented by numerical expressions, and fonts
can be enlarged, reduced, or painted in different
ways by changing the numeric values of those
expressions. Printing remains clear even if you
enlarge fonts, since the letters are defined by an
outline. You can specify font size in steps of 0.25
points up to 999.75 points.
Parallel interface
With this interface, data transfer between the
printer and the computer takes place on 8-bit
chunks. The printer can perform IEEE1284
compatible bi-directional communications.

PRESCRIBE commands

This is the Kyocera Mita page printer control
language installed on Kyocera Mita printers.
PRESCRIBE commands enable most print
settings necessary for pagination, and are easy to
understand because they are written in text
format, allowing you to do programming yourself.
For information on the commands and how to use
them, refer to the
Technical Reference
ROM supplied with the printer.

Printer driver

The printer driver makes it possible for you to
print data created using application software.
The printer driver for the printer is contained on
the Kyocera Mita Software Library CD-ROM
supplied with the printer. Install the printer
driver on the computer connected to the printer.

Process unit

This is the printer's main module and contains
the photosensitive drum and developer unit.

RAM disk

This is a virtual disk drive that uses part of the
printer's memory. With RAM disk you can set
any memory size arbitrarily, and use electronic
sorting (to reduce print time).
Simple Network Management
Protocol (SNMP)
This is a protocol for the management of
networks that use TCP/IP (Transmission Control
Protocol/Internet Protocol).
Glossary-3
Command Reference and
contained on the CD-
Glossary