Removing The Transfer Roller - Kyocera FS-1030D Service Manual

2G6

1-6-6 Removing the transfer roller

CAUTION
Do not touch the transfer roller (sponge) surface. Oil and dust (particles of paper, etc.) on the transfer roller can
significantly deteriorate the print quality (white spots, etc.).
When refitting the bushes and springs, make sure to refit the black colored bush and spring on the left side. Also,
observe the correct direction to which the bush is fit in reference to the paper passing direction.
1. Remove the process unit (See page 1-6-2).
2. Remove the transfer roller from the both bushes.
Transfer roller
1-6-8
Gear
Bush
(Black colored)
Spring
(Black colored)
Transfer roller
Figure 1-6-9 Removing the transfer roller
Paper passing direction
Wide
Narrow
Bush
Spring
Transfer roller
Bush