Panasonic PT-D9610U Operating Instructions Manual page 59

Adjusting the picture size
Adjustment procedure
MENU
AUTO SETUP
LENS
PICTURE
POSITION
OPTION
SIGNAL LIST
TEST PATTERN
MENU :
SUB MENU : ENTER
EXIT : MENU
POSITION
SHIFT
SIZE
BLK
CLOCK PHASE
INPUT RESOLUTION
CLAMP POSITION
KEYSTONE
EDGE BLENDING
MENU :
SUB MENU : ENTER
EXIT : MENU
SIZE：＊＊＊＊＊＊＊
H : nnn％
V : nnn％
SELECT : ＋−
ADJUST :
EXIT : MENU
Size modes
DEFAULT The input signal is projected with the aspect ratio unchanged.
• • •
THROUGH The input signal is projected with the resolution unchanged.
•
H-Fit The input signal is projected with all horizontal panel picture elements used.
• • • • • • • • • • •
For signals with a aspect ratio which is vertically longer than 4:3(for the PT-D9510U)/
5:4(for the PT-D9610U), the top and bottom edges of the picture are cropped.
V-Fit The input signal is projected with all vertical panel picture elements used.
• • • • • • • • • •
For signals with a aspect ratio which is horizontally longer than 4:3(for the PT-D9510U)/
5:4(for the PT-D9610U), the left and right edges of the picture are cropped.
HV-Fit The input signal is converted to an aspect ratio of 4:3(for the PT-D9510U) / 5:4(for the
• • • • • • • •
PT-D9610U).
For signals with an aspect ratio other than 4:3(for the PT-D9510U) / 5:4(for the PT-D9610U),
circles in the picture become distorted, etc.
For signals with an aspect ratio other than 5:4 circles in the picture become distorted, etc.
ZOOM The enlargement ratio of the picture is changed. The enlargement ratio in both the horizontal
• • • • • • • •
and vertical directions can be changed to between 50 % and 999 %(except analog RGB, TMDS
input), between 75 % and 999 %( up to SXGA of analog RGB, TMDS input),between 100 % and
999 %(UXGA of analog RGB, TMDS input) with the top-left corner of the screen as
the reference point.
4:3 The input signal is projected with the aspect ratio 4:3.
• • • • • • • • • • • •
16:9 The input signal is projected with the aspect ratio 16:9.
• • • • • • • • • • •
• An overscan of 7 % is applied to all modes other than analog RGB input and TMDS input.
• The 4:3 and 16:9 mode are only for YUV type signal input
Press the MENU button. ... The MENU screen will be displayed.
Press the UP ( ) and DOWN (
Press the ENTER button. ... The POSITION screen will be displayed.
Press the UP ( ) and DOWN (
Press the ENTER button. ... The SIZE screen will be displayed.
Press the control level buttons ( + and − ) to select the desired size mode from
those indicated below.
DEFAULT, THROUGH, H-FIT, V-FIT, HV-FIT, ZOOM
• "4:3", "16:9" ----- Modes other than the analog RGB or TMDS input allow the
selection.
) arrow buttons to select POSITION.
) arrow buttons to select SIZE.
59