Panasonic PT-D9610U Operating Instructions Manual page 56

Adjusting the picture to the desired setting (continued)
Adjusting the white balance (High / Low)
Adjustment procedure
MENU
AUTO SETUP
LENS
PICTURE
POSITION
OPTION
SIGNAL LIST
TEST PATTERN
SELECT :
ADJUST : ENTER
EXIT : MENU
PICTURE
COLOR TEMP : ＊ ＊ ＊ ＊
BRIGHT : nnn
CONTRAST : nnn
COLOR : nnn
TINT : nnn
SHARPNESS H : nnn
SHARPNESS V : nnn
NR : ＊ ＊ ＊ ＊ ＊
GAMMA MODE : 2.2
SELECT :
ADJUST :
SUB MENU : ENTER
EXIT : MENU
WHITE BALANCE
R : 33
G : 120
B : MIN
SELECT :
ADJUST : + –
EXIT : MENU
120 ｜ ｜ ｜ ｜ ｜ ｜ ｜ ｜ ｜ ｜ ｜ ｜
Adjustment Item
Press the [+] button.
R (Red)
Press the [−] button.
Press the [+] button.
G (Green)
Press the [−] button.
Press the [+] button.
B (Blue)
Press the [−] button.
NOTE • If these adjustments are not made correctly, none of the colors will be reproduced correctly.
• If you make an error in adjustment so that the colors do not match correctly, press the STD button
while one of the individual adjustment screens is being displayed. Only the item being displayed will be
reset to the factory pre-settings.
• The projection of a built-in test pattern (Refer to page 65.) does not allow the white balance
adjustment. Be sure to project an external input signal for this adjustment.
56
(Project a signal to be adjusted)
Press the MENU button. ... The MENU screen will be displayed.
Press the UP (
Press the ENTER button. ... The PICTURE screen will be displayed.
Press the UP (
Press the LEFT (
from those indicated below.
LOW, MID, HIGH, USER, DYNAMIC
〈 If you would like to further adjust the white balance 〉
Select USER in step
Press the ENTER button. ...
•The WHITE BALANCE HIGH (LOW) screen will be displayed.
Press the ENTER key to switch between WHITE BALANCE HIGH and WHITE
BALANCE LOW.
Press the UP (
Use the control level buttons ( + and − ) to adjust the setting level.
Operation
The red component becomes stronger.
The red component becomes weaker.
The green component becomes stronger.
The green component becomes weaker.
The blue component becomes stronger.
The blue component becomes weaker.
) and DOWN ( ) arrow buttons to select PICTURE.
) and DOWN ( ) arrow buttons to select COLOR TEMP.
) and RIGHT ( ) arrow buttons to select the desired setting
.
) and DOWN ( ) arrow buttons to select either R, G or B.
Adjustment Details Adjustment Range
Max. value 255
Min. value 0