Initial Setting Of Network Module - Panasonic PT-D9610U Operating Instructions Manual

Initial setting of network module

Operating procedure
MENU
AUTO SETUP
LENS
PICTURE
POSITION
OPTION
SIGNAL LIST
TEST PATTERN
MENU :
EXIT : MENU
OPTION
SET RUNTIME : nnnnnh
LAMP POWER : ＊ ＊ ＊ ＊ ＊ ＊
CONTRAST MODE : ＊ ＊
RS-232C SETTING
SYSTEM INFORMATION
VIDEO MODULE SETTING
NETWORK MODULE SETTING
PASSWORD
MENU :
SUB MENU : ENTER
EXIT : MENU
NETWORK MODULE SETTING
HOST NAME : PROJ01
DHCP : OFF
IP ADDR : 192. 168. 0.8
NET MASK : 255. 255. 255.0
GATEWAY : 192. 168. 0.1
MAC ADDR : 01-02-03-
04-05-06
STORE
MENU :
POSITION :
ADJUST : 0-9
EXIT : MENU
78
Press the MENU button. ... The MENU screen will be displayed.
Press the UP ( ) and DOWN (
Press the ENTER button. ... The OPTION screen will be displayed.
Press the UP ( ) and DOWN (
MODULE SETTING.
Press the ENTER button. ... NETWORK MODULE SETTING screen will be
displayed.
Press the UP ( ) and DOWN (
press the ENTER button to change the setting.(refer to next page)
Press the UP ( ) and DOWN (
press the ENTER button twice.
• After the online lamp of the network module goes out, it lights up again.
NOTE
• It takes about 2 minutes for settings to take effect.
• Do not turn off the main power supply until the online lamp of the network
module lights up again.
) arrow buttons to select OPTION.
) arrow buttons to select NETWORK
) arrow buttons to select each item and
) arrow buttons to select STORE and