Panasonic PT-D9610U Operating Instructions Manual page 58

Adjustment Item
Makes the horizontal contours sharper.
SHARPNESS H
Makes the vertical contours sharper.
SHARPNESS V
NR
Selects the noise reduction effectiveness.
(Noise Reduction)
GAMMA MODE Selects the gamma mode.
For the PT-D9510U, use this adjustment to
select interpolation filter settings for signals
other than XGA. For the PT-D9610U, use this
FILTER
adjustment to select interpolation filter settings
for signals other than SXGA.
Use this adjustment to choose the best
FRAME RATE
frame rate conversion for minimum flicker
on individual HDTV signal input.
Use this adjustment to further enhance
vertical resolution when a 576i, 1 080/50i
PAL CINEMA
PAL (or SECAM) signal is applied.
NOTE
• NR (noise reduction) settings cannot be adjusted for analog RGB input and TMDS input.
• The FILTER adjustment is ineffective for XGA (1 024 x 768) mode on the PT-D9510U, or SXGA (1 280
x 1 024) mode on the PT-D9610U. It is also ineffective for any video input mode other than analog
RGB and TMDS modes, or if "THROUGH" is chosen for the SIZE mode (see pages 60 and 61).
• Even with the above signal, adjustment is possible during keystone correction. Even with YUV type
signals, adjustment is possible during REAL keystone correction.
• FRAME RATE is effective only for analog RGB,and 1080/30p, 1080/25p, 1080/24p, and 1080/24sF
video signal formats of HD serial.
• PAL CINEMA is effective only for the 576i, 1 080/50i PAL (or SECAM) standard.
• PAL CINEMA will cause degraded picture quality (lowered vertical resolution) if used for signals other
than those pulled down at a 2:2 ratio.
• For 480p, 480i or 576i scan format, SHARPNESS H defaults to 6.
58
Operation Adjustment Details
Nine steps from OFF to 8 (factory default : 2)
A larger value causes a greater effect
Four steps from OFF to 3 (factory default : 2)
A larger value causes a greater effect
OFF: No correction
1 : Weak
2 : Medium (factory default)
3 : Strong
A larger value causes a greater effect
Two steps of 2.2 and 2.5 (factory default : 2.2)
Five types from 0 to 4 (factory default : 2)
0 : Gives priority to contrast.
4 : Restricts the loss in picture information to
a minimum.
24p 60p / 24p 24p
(factory default: 24p
25p 50p / 25p 25p
(factory default: 25p
30p 60p / 30p 30p
(factory default: 30p
24sF 60p / 24sF 24p / 24sF
(factory default: 24sF
OFF : No cinema processing
AUTO : Auto detection (factory default)
ON : Cinema processing (see the following notes)
60p)
50p)
60p)
48i
60p)