Table of Contents
Advertisement
Problem
While programming, the
handset starts to ring.
Making/answering calls, intercom
Problem
Static is heard, sound
cuts in and out.
Interference from other
electrical units.
The handset does not
ring.
I cannot make a call.
I cannot redial by
pressing {REDIAL}.
I cannot have a
conversation using the
headset.
I cannot make long
distance calls.
I cannot page the
handset or base unit.
I cannot turn the clarity
booster feature on.
The interrupt tones sound
while I am on an outside
call or on an intercom call
or monitoring a room.
For assistance, please visit http://www.panasonic.com/phonehelp
Cause & solution
L A call is being received. Answer the call and start again
after hanging up.
Cause & solution
L Move the handset and the base unit away from other
electrical appliances (microwave, wireless LAN
appliance, etc.).
L Move closer to the base unit.
L Raise the base unit antennas.
L Turn on the clarity booster feature (page 22).
L The ringer volume is turned off. Adjust it (page 43, 54).
L The dialing mode may be set incorrectly. Change the
setting (page 48).
L The base unit (including answering system) or another
handset is in use. Try again later.
L If the last number dialed was more than 48 digits long,
the number will not be redialed correctly. Dial the
number manually.
L Make sure that a Panasonic optional headset is
connected properly (page 58).
L If "SP-phone" is displayed on the handset, press {C}
to switch to the headset.
L Make sure that you have long distance service.
L The called handset is too far from the base unit.
L The called unit is in use. Try again later.
L The resources available for wireless communication
(making or answering calls with another handset,
monitoring camera images from a computer, etc.) are
limited. Wait for the other user to end the operation and
try again.
L A call is being received. Press {OFF} to end the call or
stop monitoring, then answer the call.
Useful Information
63
Advertisement
Table of Contents
