Xerox 6110MFP/XN Service Documentation page 40

Disassembly and Reassembly
6. For easy disassembly, release the Link1 Harness and
Link2 Harness, as shown below.
Link1 Harness
Link1 Harness
7. Remove the two screws securing the Upper Frame
part and then separate the Lower Frame part in the
direction of arrow, as shown below.
3
1
Upper Frame Part
Notice: Be careful especially not to damage the covering
of the Fuser Ass'y (If the cover is damaged, it
could cause an electric leakage)
8. Remove the two screws securing the Release
Lever(L, R) below the both side of the Halogen Lamp
and then remove the Release Lever(L,R) in the
direction of arrow.
Release Lever, L
Link2 Harness
Lower Frame Part
2
Release Lever, R
9. Take out the Halogen Lamp in the direction of arrow
and then release the Heat Roller, as shown below.
Ground Spring
Bearing, L
2
Heat Roller
Upper Frame
Notice: Be careful not to damage or contaminate the
surface of the roller when assembling and
disassembling the Heat Roller.
10. Release the Pressure Shaft Roller and Pressure
Roller in the direction of arrow, as shown below.
Bush 2PR, L
Pressure Shaft Roller
Pressure Roller
Halogen Lamp
Bearing, R
Fuser Gear
2
1
Lower Frame
Bush 2PR, R