Table of Contents
Advertisement
Messages/Second messages
HDD Full
HDD Full
HDD Not Installed
Hex Dump Mode
I/O Buffer Overflow
Invalid Password
Try Again
Load Correct
Size Paper
/Press #
to Continue
Error & Status Messages on the Control Panel
Description
The maximum HDD area size
for form/font has been ex-
ceeded.
The optional Hard Disk Drive
is full. The sample print job or
locked print job to be sent
from the computer is too large
to store.
You cannot print the sample
print and the locked print
jobs, because the optional
Hard Disk Drive is not in-
stalled.
The printer is in Hex Dump
Mode.
There is too much data for the
I/O buffer to handle.
The password was not en-
tered correctly.
The paper size setting on the
tray differs from that of actual
paper size in the tray.
Solution
Delete the disused form/font
types.
Delete any unnecessary stored
files.
Install the Hard Disk Drive.
See "Hard Disk Drive Type
2600" in the Setup Guide.
Wait for a while. If the "Hex
Dump Mode" message does
not change, on the panel dis-
play press { { { { On Line} } } } to return
to the "Ready" condition.
Make sure the interface cable
is inserted into the printer and
your computer securely.
Make sure the interface cable
is not damaged or broken.
Increase the size of the I/O
buffer.
Wait for two seconds until the
previous display appears.
Then enter the password cor-
rectly.
Load { paper size } paper of
the selected feed direction and
paper size into the tray. Print-
ing will not automatically
resume if the paper size and
direction setting is incorrect.
Make sure that the paper feed
directions set in the printer
driver and on the control pan-
el are the same. There are two
methods to resume printing.
A
Use the control panel to set
the correct paper size and
direction of the paper in
tray. Then press { { { { Enter #} } } } .
Press { { { { Form Feed} } } } and se-
B
lect the tray with the con-
trol panel.
5
65
Advertisement
Table of Contents
