JUKI LZ-2290C-F Instruction Manual page 31

     

6) Correction value [%] to be employed when the sewing machine runs at 150 sti/min can be set by press-
 . This value can be increased / decreased with
ing
When the pedal is depressed in the case of selecting
the maximum sewing speed of 150 sti/min using set needle thread tension
 .
7) Correction value [%] to be employed when the sewing machine runs at 1000 sti/min can be set by press-
 .
ing
As in the case of 6), the sewing machine is able to perform sewing at the maximum sewing speed of
1000 sti/min.
 is selected, the correction value [%] to be employed when the sewing machine runs at 2000
8) When
sti/min can be set.
As in the case of 6), the sewing machine is able to perform sewing at the maximum sewing speed of
2000 sti/min.
 is selected, a correction value [%] for the number of revolutions set with U044 "Max. sewing
9) When
speed position" can be set.
As in the case of 6), the sewing machine is able to perform sewing at the maximum sewing speed set
with U044 "Max. sewing speed position".
10) The aforementioned result of settings can be checked on thread tension chart  .
11) Set values  through  can be reset to the initial value of 100 by pressing
 is disabled during sewing. After the completion of thread trimming, it becomes enabled and can
12)
be pressed to return the screen to the "S079 Needle thread tension correction screen".
 

5) The set values of needle thread tension
 and stitch length
increased / decreased with
* Needle thread tension  set in the aforemen-
tioned procedure is used for setting the cor-
rection chart. It is not reflected to the needle
thread tension that can be set in the sewing
pattern data.
 .
 , the sewing machine performs sewing at
– 26 –
 can be
 .
 and stitch length
 .