Installing The Electrical Box; Preparing For Installation Of The Control Box (Only For The Eu Type Models) - JUKI LZ-2290C-F Instruction Manual

2-9. Installing the electrical box

2-9-1. Preparing for installation of the control box (Only for the EU type models)

2-9-2. Installing the electrical box
❷
a
❶
❷
❸
❷
a
❸
❹
❺
❷
Frame
Pedal sensor
❸
❹
❺
1) Underside cover ground wires ❷ are attached
to the underside cover. Secure underside cover
ground wired ❷ on electrical box ❶ with screws.
At this time, remove once the mounting screws
from the underside cover.
Install the electrical box to the frame located be-
hind the electrical box in the upward direction as
shown in the figure. Use mounting screws ❸ that
has been preliminarily attached to the frame.
❶
Install control box ❶ on the table using four holes a
in the table. Secure the control box with four bolts ❷ ,
four plain washers ❸ , four spring washers ❹ and
four hexagonal nuts ❺ supplied with the control box.
At this time, insert the nut and washer supplied with
the unit as accessories as shown in the figure so
that the control box is securely fixed.
– 7 –