Empire Comfort Systems Breckenridge VFP32FB0L-4 Installation Instructions And Owner's Manual page 11

5. Push the handle for "Open" position and pull the handle
for the "Closed" position. See Figure 17.
CLOSED
Figure 17
28187-1-0212
Completion of Air Kit installation
1. Determine the length of 4" Dia. rigid or flex duct con-
OPEN
2. Secure the 4" dia. duct to the Slide Assembly collar on
3. Run the other end of the duct through the exterior wall
4. From the outside of the building, connect the duct to the
5. Secure the Outside Air Vent Assembly to the outside
6. Figure 19 illustrates the various options for installation
nector (installer supplied) you will need from the fire-
box/fireplace to the exterior surface of the outside wall,
where the air kit hood will be installed. Add a few extra
inches to the length to allow for easier attachment of
the outside duct connection prior to securing the out-
side rain cap hood to the building.
the firebox with band clamps or screws (installer sup-
plied).
cutout.
collar on the outside air vent assembly with band clamp
or screws to secure (installer supplied).
wall with the four 10 x 1 1/2 Hex Head Slotted Screws
provided. Seal with caulk as necessary. See Figure 6.
of the air duct run possibilities.
CAULKING
WALL
Caulk and Install Duct Termination
Figure 18
Figure 19
OUTSIDE
AIR VENT ASSY
Page 11