Download Print this page

Operation - Crown EC-20T Installation & Operation Manual

Self-generating steam jacketed tilting kettle

Advertisement

Self-Generating Steam Jacketed Tilting Kettle

Operation

Operating Instructions
1. Ensure that the external electrical service to kettle is on.
2. Check pressure gauge for correct cold kettle reading. Reading should be in the green vacuum zone (25 - 30 In. Hg or
635 - 762 mm Hg of vacuum). If reading is not low enough, follow VENTING INSTRUCTIONS in this Section prior to
using kettle.
3. Place power switch in ON position.
4. Preheat kettle by placing thermostat knob at Maximum Temperature. Wait until TEMPERATURE light goes off.
5. Add food to be cooked into kettle.
6. Place thermostat knob at required temperature setting from 1-10 coinciding with the following table:
7. When cooking is finished, place power switch in OFF position.
8. Pour finished product from kettle using tilt handle. Be careful to avoid splashing.
9. Add water to kettle for cleaning purposes.
10. Wash kettle thoroughly. See CLEANING INSTRUCTIONS.
Tilting Instructions
Your kettle has a standard "Clean Lock" feature and may not be tilted without disengaging the tilt knob located on the
console at the top right. This feature locks the kettle in the upright position and also allows the operator to lock the kettle at
105 degrees for ease of cleaning. To tilt the kettle the full distance, the tilt lock knob must be disengaged from the cleaning
position by pulling out the tilt lock knob and tilting the kettle forward the full distance. Follow these steps to tilt kettle:
1. Pull out the tilt knob at top right located on console.
2. Using kettle tilt handle pull kettle forward to desired angle of pour or until kettle locks at 105 degrees. The tilt knob can
be released after the kettle has been tilted approximately 10°.
3. Kettle will lock in position at 105 degrees and may be tilted further by pulling the tilt lock knob a second time allowing
the kettle to tilt the full distance.
4. To return the kettle to the upright position, pull out the tilt lock knob and tilt the kettle upward until it locks in the
upright position. The kettle should not move in either direction once in the upright position.
INSTALLATION & OPERATION MANUAL 10067 REV 8 (12/21)
Thermostat
Approximate (Jacket) Temperature
Setting
1
90 Fahrenheit
2
118 Fahrenheit
3
138 Fahrenheit
4
158 Fahrenheit
5
178 Fahrenheit
6
200 Fahrenheit
7
220 Fahrenheit
8
240 Fahrenheit
9
260 Fahrenheit
10
280 Fahrenheit
30 Celsius
42 Celsius
54 Celsius
64 Celsius
76 Celsius
88 Celsius
100 Celsius
111 Celsius
122 Celsius
134 Celsius
O
PERATION
7
PAGE
OF24

Advertisement

loading