Getting Started; Battery Installation; Ac Adaptor Connection - Oregon Scientific 14894 Instruction Manual

Chapter 2
Chapter 2

Getting Started

Battery Installation

1. Make sure the unit is turned off.
2. Using a Phillips screwdriver, open
the battery cover at the back of the unit.
3. Insert 4"AA" batteries.
(Note the correct polarity: +, - ).
4. Replace the cover.
(The unit is automatically turned on
as soon as the batteries are installed
or the adaptor is plugged in.)

AC Adaptor Connection

Plug the adaptor into the adaptor jack
on the left side of the unit.
Plug the adaptor into a wall outlet
Auto-off
The learning PC will be automatically turned off after about 5 minutes of no input from the player
Your Zip the Robot Learning PC operates on 4 AA size batteries (not included) or
a 9V AC adaptor (sold separately).
+
-
.
Caution
• Different types of batteries or new and used batteries are not
to be mixed.
• Only batteries of the same or equivalent type as recommended
are to be used.
• Remove all batteries when replacing.
• Remove batteries from the unit if the unit is not going to be
used for long periods.
• Do not dispose of batteries in fire.
• Non-rechargeable batteries are not to be recharged.
• Rechargeable batteries are to be removed from the toy
before being charged. (if removable)
• Rechargeable batteries are only to be charged under adult
supervision. (if removable)
• Exhausted batteries are to be removed from the toy.
• The supply terminals are not to be short-circuited.
Caution
• The unit must not be connected to more than a 9V power supply.
• The unit must only be used with the recommended adaptor.
• The adaptor is not a toy.
• The supply terminals are not to be short-circuited.
• Toys liable to be cleaned with liquid are to be disconnected
from the transformer before cleaning.
.
3