PT18-Manual (US)
6/14/02
Chapter 2
Chapter 2
Getting Started
The Accelerator PC Trainer Plus operates on 4 AA size batteries (not included) or a 9V AC
adaptor (sold separately).
Battery Installation
1. Make sure the unit is turned off.
2. Using a Phillips-head screwdriver, open the battery cover at the back of the unit.
3. Insert 4 "AA" batteries. (Note the correct polarity: +, - ).
4. Replace the cover.
AC Adaptor Connection
Plug the adaptor into the adaptor jack
(center positive type) on the left side of the unit.
Plug the adaptor into a wall outlet.
Pls. turn off the unit before plugging in the AC
adaptor. Otherwise the unit may be damaged.
5:53 PM
Page 6
+
-
Caution
• Do not mix different types of batteries or old and new batteries.
• Only use batteries of the same or equivalent type as recommended.
• Remove all batteries when replacing.
• Remove batteries from the unit if the unit is not going to be used
for long periods of time.
• Do not dispose of batteries in fire.
• Do not recharge non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toy before
being charged.
• Rechargeable batteries are only to be charged under adult supervision.
• Remove exhausted batteries from the toy.
• Do not short-circuit the supply terminals.
Caution
• The unit must not be connected to a power supply greater than 9V.
• Only use the recommended adaptor.
• The adaptor is not a toy.
• Do not short-circuit the supply terminals.
• Toys liable to be cleaned with liquid are to be disconnected
from the transformer before cleaning.
2