Table of Contents
Advertisement
BD18-Manual (AU)
1/18/06
11:47
Chapter 2
Chapter 2
Getting Started
Your Accelerator Power Desktop operates on 3 AA-size batteries or a 9V AC adaptor.
Connecting the Base
1. The Accelerator Power Desktop is packaged with the base separate
from the rest of the unit.
2. To attach the base, place the base on a flat surface with the curved edge
facing backwards.
3. Hold the screen part facing forward, with the keyboard folded up.
4. Insert the screen part into the slot, securing the right-hand guide prong first.
5. Push the left-side down until it clicks into place.
6. To release the base, use the base release button on the underside of the unit.
Battery Installation
1. Make sure the unit is turned off.
2. Using a Phillips-head screwdriver,
open the battery cover at the back
of the unit.
3. Insert 3 AA-size batteries.
(Note the correct polarity: +, - ).
4. Replace the cover.
Page 7
Caution
• Do not mix different types of batteries or old and new batteries.
• Only use batteries of the same or equivalent type as
+
-
recommended.
• Remove all batteries when replacing.
• Remove batteries from the unit if the unit is not going to be
used for long periods of time.
• Do not dispose of batteries in fire.
• Do not recharge non-rechargeable batteries.
• Rechargeable batteries are to be removed from the toy
before being charged.
• Rechargeable batteries are only to be charged under adult
supervision.
• Remove exhausted batteries from the toy.
• Do not short-circuit the supply terminals.
Right
Hand
Guide
Prong
3
Advertisement
Table of Contents
