Special Features; Remote Control Functions - JVC G-code ShowView HR-S5900AM Instructions Manual

42
EN
Rem ote
Control
Functions
VCR
NUMBER "1"
Remote A/ B Code Sw itching
The remote control is capable of controlling two JVC video
recorders independently; one set to respond to the remote
control's A code control signals and another set to respond to B
code control signals. The remote control is preset to send A
code signals because your video recorder is initially set to
respond to A code signals. You can easily modify your video
recorder to respond to B code signals.
1
2
3
To control tw o recorders w ith the
sa me remote control
You can control two JVC recorders by switching the remote
control code for the remote control between A and B (
1), keeping two recorders to different control codes.
● To change only the remote control code for the remote
control, DO NOT perform steps 2 and 3.
N O TE:
To set the recorder back to respond to A code signals, repeat the
OK
same procedure as shown above except pressing NUMBER key
"1" instead of "2" in step

SPECIAL FEATURES

SET REMO TE CO N TRO L
CO DE FO R REMO TE
CO N TRO L
1
Press and hold VCR.
2
Press the NUMBER key "2".
3
Press OK, and release VCR.
● The remote control now can transmit B code control
signals.
CHECK REMO TE CO N TRO L
CO DE FO R RECO RDER
Press and hold PLAY on the recorder for more than
5 seconds while the recorder is turned off. The code
currently set appears on the display panel.
CHAN GE CO DE FO R
RECO RDER
Press any key on the remote control. The recorder now
responds to B code control signals.
2
of 1.
step