JVC G-code ShowView HR-S5900AM Instructions Manual page 7

SET VIDEO CHAN N EL
3
Set your TV to UHF channel 36.
● If the two vertical white bars appear clearly on the
screen as shown in the illustration (
on page 6), press
● If the two vertical white bars do not appear clearly,
press and then
O K
to a vacant channel between 28 and 60 which is not
occupied by any local station in your area.
(Ex.) If channel 50 is available in your area
Then set your TV to UHF channel 50 and check if the
two vertical white bars appear clearly on the screen; if
so, go to step . If not, re-set the video recorder to
4
another vacant channel and try again.
N O TES:
● If you set the video recorder to a channel which is
occupied by a local station or has neighbouring
channels that are occupied by local stations, the
picture reception quality will be affected and some
interference noise will appear on the TV screen. Be
sure to select a vacant channel which has no
broadcast on neighbouring channels.
● If you cannot obtain the two vertical white bars
clearly with any channel between 28 and 60, consult
your JVC dealer.
FIN ISH VIDEO CHAN N EL
SET
4
Press .
O K
If Auto Set U p (
●
has not previously been performed, the Language
Select screen appears and Auto Set U p function
takes place automatically.
○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○ ○
Be sure to connect the power plug to an AC outlet first
before installing the lithium battery; otherwise, the
battery's service life will be drastically shortened.
"TEST SIGNAL"
and then go to step .
O K 4
to set the video recorder
PR +/ –
pg. 8) or Tuner Set ( pg. 54)
(MONO)
A
W ith AV Connection or
S-VIDEO Connection
IM PO RTAN T:
Before performing the following steps, make sure the
recorder's power is off and there is no cassette inserted in
the recorder.
ACCESS VIDEO CHAN N EL
SET MO DE
1
Hold down
STO P/ EJECT
display panel shows the following.
SET VIDEO CHAN N EL
2
Press , then press
O K
the following.
Now the video channel is set to off (– –).
FIN ISH VIDEO CHAN N EL
SET
3
Press .
O K
If Auto Set U p (
●
has not previously been performed, the Language
Select screen appears and Auto Set U p function
takes place automatically.
To view picture signals from the video recorder, set
your TV to its AV mode.
Installing/ Removing the lithium battery
1
Make sure that the power plug is connected to an AC outlet
2 and turn off the recorder power.
Open the battery cover while pressing the release tab as
3
illustrated.
Insert a lithium battery with the plus (+) side up and push it in.
To remove the lithium battery, press the latch A down-
●
ward using a pointed non-metallic object, then pull out
4 the lithium battery.
Close the battery cover until it clicks in place.
EN
on the recorder until the
until the display panel shows
PR –
pg. 8) or Tuner Set ( pg. 54)
7