Connecting A Turntable (Phono); Connecting A Cassette Tape Deck, Md Recorder, Dat Deck, Or Cd Recorder (Tape); Connecting The Power Cords From Other Devices - Onkyo TX-NR801 Instruction Manual

Connecting to Audio/Video Equipment—Continued

Connecting a Turntable (PHONO)

DIGITAL PRE OUT
IN ANTENNA
R L
COAX FRONT
1
SUB CENTER
2
SURR
3
SURR
R L
BACK/
OPT
ZONE 2
1
FRONT
MULTI CH
2
INPUT
AUDIO
R L
R
SUB CENTER
3
SURR
DIGITAL
OUT
R L
OPT
1
SURR
BACK
2
GND
R
AUDIO
Ground wire (earth)
Using an RCA audio connection cable, connect the
output jacks of the turntable to the PHONO audio jacks
of the TX-NR801/TX-NR801E. Make sure that you
properly connect the left channel to the L jack and the
right channel to the R jack.
Note:
The TX-NR801/TX-NR801E is designed for use with
moving magnet cartridges. For proper operation, con-
nect a ground (or earth) wire to the GND terminal. For
some turntables, however, connecting the ground wire
may cause increased noise, and in such a case, a ground
wire is not necessary and should not be connected.
Connecting a Cassette Tape Deck,
MD Recorder, DAT Deck, or CD
Recorder (TAPE)
DIGITAL
IN
COAX
1
2
DIGITAL
3
IN
OPT
1
OPT
2
2
3
DIGITAL
OUT
OPT
DIGITAL
1
OUT
2
OPT
1
DIGITAL
OUT
OPT
MD recorder, DAT deck,
or CD recorder
Using RCA audio connection cables, connect the output
jacks (PLAY) of the device to the TAPE AUDIO IN
jacks of the TX-NR801/TX-NR801E and connect the
input jacks (REC) of the device to the TAPE AUDIO
OUT jacks of the TX-NR801/TX-NR801E. Make sure
that you properly connect the left channels to the L
jacks and the right channels to the R jacks.
If the device has a digital output, connect it to either the
24
COMPONENT
AUDIO VIDEO S VIDEO
VIDEO
AUDIO
OUTPUT
MONITOR
OUT Y
R L
AM
OUT ZONE 2 P
B
R L PHONO
IN DVD P
IN R
INPUT 1
FM
OUT Y
75
VIDEO 1
IN P
B
L
PHONO OUT P
R
IN
VIDEO 2
INPUT 2
CD IN Y
IN
OUT
IN VIDEO 3 P B
TAPE
IN VIDEO 4 P R
IN
L R L
AUDIO VIDEO S VIDEO
PRE OUT COMPONENT
AUDIO VIDEO S VIDEO
L ANTENNA VIDEO
R
FRONT
OUTPUT
MONITOR
OUT
Y
SUB CENTER
AM
OUT ZONE 2 P B
R L
SURR
IN DVD P
R
SURR
R L
BACK/
INPUT 1
ZONE 2 OUT
FM
OUT Y
75
VIDEO 1
FRONT
MULTI CH
IN P
B
INPUT
AUDIO
R L
R L
TAPE
SUB CENTER
PHONO OUT P R
IN
VIDEO 2
INPUT 2
SURR
CD IN Y
IN
R L
OUT
IN
IN VIDEO 3 P
B
SURR
BACK
TAPE
R L
IN VIDEO 4 P
R
IN
GND AUDIO
R L R L
AUDIO AUDIO VIDEO S VIDEO
DIGITAL
R L R
AUDIO OUT AUDIO IN
IN
OPT
Cassette tape deck, MD recorder,
DAT deck, or CD recorder
DIGITAL IN COAX jack or DIGITAL IN OPT jack of
the TX-NR801/TX-NR801E, depending on the type of
connector on the device.
On the initial settings of the TX-NR801/TX-NR801E,
the TAPE input source is set for digital input at the
OPT 2 jack.
If the digital connection is made to a different jack, this
must be changed at Setup Menu → Input Setup →
Digital Setup (See page 36).
If the device has a digital input, connect it to the
DIGITAL OUT OPT jack of the TX-NR801/
TX-NR801E for digital recording of the REC OUT
signal from the TX-NR801/TX-NR801E.
However, if the same device also has a digital output and
it has already been connected to the TX-NR801/TX-
NR801E, you cannot connect the digital input of the
device to the DIGITAL OUT jack of the TX-NR801/TX-
NR801E simultaneously.
Note:
The output from the DIGITAL OUT jack of the
TX-NR801/TX-NR801E is only the digital signal input
to the DIGITAL IN jack.
Connecting the Power Cords from
Other Devices
The TX-NR801/TX-NR801E is equipped with AC mains
outlets for connecting the power cords from other devices
so that their power is supplied through the TX-NR801/
TX-NR801E. By doing this, you can leave the connected
device turned on and have the STANDBY/ON button on
the TX-NR801/TX-NR801E turn on and off the device
together with the TX-NR801/TX-NR801E.
The shape, number, and total capacity of the AC
outlets may differ depending on the area of purchase.
Caution:
Make sure that the total capacity of the components connected
to the TX-NR801/TX-NR801E does not exceed the capacity
that is printed on the rear panel (e.g., TOTAL 120W).
L
European and some
Asian models
Worldwide model
AC OUTLETS AC OUTLETS
AC 120 V 60 Hz
SWITCHED
TOTAL 120W 1A MAX.
AC 230-240 V 50 Hz
SWITCHED
TOTAL 100 W MAX.
USA and Canadian
models
AC OUTLET
AC OUTLET
AC 230-240 V
SWITCHED
SWITCHED 100W MAX.
100W MAX.
Australian model
50 Hz