Temporarily Changing The Speaker Output Levels; Using The Sleep Timer (Remote Controller Only); Adjusting The Brightness Of The Front Display - Onkyo TX-NR801 Instruction Manual

Enjoying Music or Videos with the TX-NR801/TX-NR801E—Continued
DISPLAY DIMMER
DIRECT / PURE AUDIO STEREO
AUDIO SELECTOR
SLEEP
RCVR
CH SEL
AUDIO SEL
DISPLAY
DIMMER
Temporarily Changing the Speaker Output
Levels
To change the individual speaker volumes temporarily,
follow the procedure given below. Each channel can be
set between –12 and +12 decibels (between –15 and
+12 decibels for the subwoofer). Note that the speaker
volumes will return to the original settings when the
TX-NR801/TX-NR801E is put in the standby state.
1 Press the RCVR MODE button.
2
Press the CH SEL button and
select the desired speaker.
3
Press the LEVEL
adjust the volume level.
Notes:
• You cannot select a speaker if it is set to "No" or
"None" in the Speaker Config Sub-menu of the
Speaker Setup Menu.
• To have your new speaker levels set here, overwrite
the settings at Setup Menu → Speaker Setup Menu
→ Level Calibration Sub-menu, and press the TEST
button after you complete step 3 in the procedure
above.
40
SETUP
TUNING
ENTER
RE TURN
PRESET
SURROUND THX DSP MEMORY FM MODE A-FO RM LISTENING MODE MEMORY
TEST
LEVEL /
or button to

Using the Sleep Timer (remote controller only)

With the sleep timer you can set the TX-NR801/
TX-NR801E so that it automatically turns off after a set
period.
Press the [SLEEP] button repeat-
Remote
edly to select the required sleep
controller
time.
You can set the sleep time from 90 to 10
minutes in 10 minute increments.
The SLEEP indicator appears on the dis-
play when the sleep timer has been set,
as shown. The specified sleep time
appears on the display for about five sec-
onds, then the previous display reap-
pears.
To cancel the sleep timer, press the
[SLEEP] button repeatedly until the
SLEEP indicator disappears.
To check the remaining sleep time,
press the [SLEEP] button. Note that if
you press the [SLEEP] button while the
sleep time is being displayed, you'll
shorten the sleep time by 10 minutes.
Using the sleep timer only for Zone 2:
If you are using the remote zone (Zone
2), it will turn off at the same time as the
main zone. If you want to set the sleep
function for Zone 2 only, set the sleep
function with main zone turned on and
then put the main zone into the standby
state.

Adjusting the brightness of the front display

You can adjust the brightness of the front display of the
TX-NR801/TX-NR801E using the DIMMER button on
the remote controller or on the TX-NR801/TX-NR801E
front panel (other than European models).
TX-NR801/
Use the DIMMER button to select:
TX-NR801E
dim, dimmer, or normal
DIMMER
brightness.
Remote
controller