Terminal Setup - Furuno INMARSAT-C FELCOM 18 Operator's Manual

3.2

Terminal Setup

The [Terminal Setup] menu provides for selection of connection point, date display for-
mat, screen saver on/off and window colors.
1. Press the F8 and 3 keys to show the [Terminal Setup] menu.
Date Disp. Form DD-MMM-YY
Screen Saver
Window Color
2. For a 2nd DTE, do steps 1) - 2) below. Otherwise, skip to step 3.
1) Select [Connection] then press the Enter key to show the [Connect List]. The
[Connect List] shows the names of the FELCOM 18 terminals available for
communication.
Note: The No. Name, IMN, IP address/subnet mask and software version of
each terminal are shown. The asterisk marks the FELCOM 18 terminal cur-
rently selected for communication.
2) Select the FELCOM 18 terminal to connect then press the Enter key.
3. Select [Date Disp. Form] then press the Enter key to open its options window.
4. Select [YY-MM-DD], [MMM-DD-YY] or [DD-MMM-YY] as appropriate then press
the Enter key.
5. Select [Screen Saver] then press the Enter key.
6. Turn the screensaver ON or OFF as appropriate then press the Enter key. When
enabled, the screensaver automatically starts 10 minutes after there is no key op-
eration. To release the screensaver, press any key.
Terminal Setup
OFF
IC-218
Connection List
No. Name IMN
01 F18_123456 123432588 172.31.16.2
02 F18_133234 456789210 192.168.16.2
03
04
05
06
07
08
09
10
Other
Terminal Setup
Connection
Date Disp. Form DD-MMM-YY
Screen Saver OFF
Window Color
Window Size Normal
2nd DTE
IP Address Software Version
1650247-xx
1650247-xx
3. SYSTEM INITIALIZATION
3-3