Standby Display - Furuno INMARSAT-C FELCOM 18 Operator's Manual

2.5

Standby Display

After the equipment is turned on and the diagnostic test is completed, the standby dis-
play appears, showing the results of the test. The system status monitor provides var-
ious operating information. For further information, see section 10.4.
File Edit
Date
Time
Position
Waypoint
Course
Speed
Current NCS
Current Channel
Current TDM
MES Status
GPS Status
DCE Memory
Current State: IDLE
DCE F18 Ver. xx
xx: Program Version No. of TERMCPU Board
After the diagnostic test is completed, the equipment automatically starts synchroniz-
ing itself with a satellite. When the indication "Retuning" is replaced with
"SYNC(NCS)", the synchronization process is completed. Then, you are ready to re-
ceive EGC messages. See section 3.4.
Note: When the caution "Pre-set LES ID for DISTRESS ALERT is invalid in the pres-
ent ocean region. Please input preferred LES ID in the [Distress Alert Setup] menu."
appears. Change the LES ID in the distress alert setup to match current ocean region.
See section 7.2.
Transmit EGC Reports Logs
Jan-12-12
01:32 (UTC)
LAT 34:30.00N
LON 135:00.00E
LAT
LON
345.5 DEG
10.2 kn
344 (IOR/EMEA) LOGOUT
NCS CC
NCS CC
Idle
****
32818 Bytes free
Retuning
NCS: IOR/EMEA LOGOUT
REC. MESSAGE EXIST
2. OPERATIONAL OVERVIEW
Options Setup Distress StopAlarm
IMN: 443156710
BBER 000
C/N OK (
Send Level OK (
Rx AGC Level OK (254)
REF Offset Freq OK (
Synthe Local OK
TCXO Control 131
Antenna Power Supply OK(7.4V)
Water Temperature
68.2 DEG
Water Current
Direction
232 DEG
Speed
1.9 kn
Depth
Jan-12-12 01:32 (UTC)
LAT: 34:30.00N
LON: 135:00.00E
0 dB)
0)
0 Hz)
2-7