Table of Contents
Advertisement
8. Display the sounder screen to measure how many feet the transmitting line of HIGH
and LOW frequencies is shifted by VRM marker.
Transmitting line is low: to the next step,
Transmitting line is same position: The setting is finished.
9. Turn the power off, and on again while holding any key down.
10.Select DRAFT ADJUSTMENT with [ ] key.
11.Press the [MENU] key.
12.Enter the value of the transmitting line measured in step 8 with - (minus). at the DRAFT
ADJ (H) EXT and DRAFT (L) EXT line with [t]/[s]
13.Press the [MENU] key to return to SYSTEM menu.
3.4 Nav Data Setting
1. Select NAV DATA SETTING (NMEA) from the SYSTEM menu and press the [MENU]
key.
2. Set baud rate of navigator with [t]/[s].
3. Select NAV DATA with [ ]/[ ].
4. Set type of NMEA talker of navigator (GPS, Loran C, Loran A, Decca, DR, AUTO) with
[t]/[s]. Select AUTO when more than one navigator is connected, and the priority is
GPS, Loran C, Loran A, Decca, DR.
5. Select NMEA VERSION with [ ]/[ ].
6. Set NMEA version of navigator with [t]/[s]. If you are unsure of version number try
both and select the one which successfully receives nav data.
7. Select DISPLAY DATA with [ ]/[ ].
8. Select L/L or TD as appropriate with [t]/[s].
9. Select TLL OUTPUT with [ ]/[ ]. (This enables/disables L/L position output when the
[MARKER] key is operated.)
10.Select ON or OFF as appropriate with [t]/[s].
11.Press the [MENU] key to close the menu and return to the SYSTEM menu.
[NAV DATA SETTING (NMEA)]
BAUD RATE (NMEA)
: 600
NAV DATA
: DR
NMEA VERSION
: Ver 1.5 Ver 2.0
DISPLAY DATA
: L/L
TLL OUTPUT
: OFF
[ ] [ ] : Select item.
[t] [s] : Change setting. (or [-], [+])
[MENU] : Return to SYSTEM MENU.
Figure 3-7 NAV DATA SETTING (NMEA) menu
1200
2400
AUTO
LC...
TD
TIMER
ON
19
4800
Advertisement
Table of Contents
