Maintenance - Husqvarna YTH24K54 Operator's Manual

To install the mulch plug (accessory)
The product can be used with a mulch plug.
1. Put the cutting deck in the transport position.
To set the cutting deck in transport
Refer to
position or mow position on page 13 .
2. Remove the grass catcher or the rear discharge
deflector (accessory) if it is installed.
3. Put the mulch plug through the back plate and
into the chute adaptor for the cutting deck.
4. Connect the 2 straps to the holes on the support
arms for the grass catcher.
5. Install the grass catcher or the rear discharge
deflector.
6. Remove the mulch plug in the opposite
sequence.
To install the rear discharge
deflector (accessory)
The product can be used with a rear discharge
deflector.
1. Put the cutting deck in the transport position.
To set the cutting deck in transport
Refer to
position or mow position on page 13 .
2. Remove the grass catcher.
3. Remove the mulch plug (accessory) if it is
installed.
Introduction
WARNING:
the safety chapter before you do
maintenance on the product.
2047 - 001 - 04.01.2023

Maintenance

Read and understand
4. Install the discharge chute through the opening in
the backplate and move the cutting deck adapter
onto it.
5. Install the 2 wing nuts.
6. Install the rear discharge deflector to the
backplate with the 4 screws.
7. Tighten the screws fully.
8. Remove the rear discharge deflector in the
opposite sequence.
To install the grass catcher
(accessory)
The product can be used with a grass catcher.
1. Put the cutting deck in the transport position.
To set the cutting deck in transport
Refer to
position or mow position on page 13 .
2. Remove the rear discharge deflector (accessory)
or the mulch plug (accessory) if it is installed.
3. Put the discharge chute through the back plate
and into the chute adaptor for the cutting deck.
4. Install the 2 wing nuts.
5. Install the grass catcher.
6. Remove the grass catcher in the opposite
sequence.
17