Husqvarna YTH24K54 Operator's Manual page 22

To examine the transaxle pump fluid
• Make sure that the transaxle pump fluid does not
leak.
• Speak to the nearest approved service center or
department if the transaxle pump fluid leaks.
To adjust the front wheel toe-in and camber
The front wheel toe-in and camber is correctly set at
the factory. The front wheel toe-in and camber are
not adjustable.
• Speak to an approved service center if the
factory-set front wheel toe-in or camber is
damaged.
To replace the fuse
This product has an automotive-type fuse. The fuse
holder is located behind the dashboard.
1. Hold the fuse holder and pull the blown fuse out.
2. Put a new fuse in the fuse holder.
To remove and install the engine cover and
the grill assembly
1. Lift the engine cover.
2. Disconnect the headlight wire connector (A).
3. Stay in front of the tractor. Hold the engine cover
on its sides. Tilt the engine cover in the direction
of the engine and lift it to remove it from the
product.
4. Install in the opposite sequence.
To replace the drive belt
1. Park the product on a level surface and engage
the parking brake. Refer to
rearward on page 14 .
2. Remove the cutting deck. Refer to
and disengage the cutting deck on page 16 .
22
A
To move forward and
To engage
3. Remove the drive belt from the pulley (A) and the
clutch pulley (B).
E
F
A
B
D
4. Remove the drive belt from the belt tension
pulley (C).
5. Pull the drive belt rearward and remove it from
the transmission input pulley (D) and above the
cooling fan blades.
6. Remove the drive belt from the engine pulley (E)
on the engine shaft.
7. Move the drive belt rearward and above the
steering plate (F) to remove the drive belt from
the product.
8. Install a new drive belt in the opposite sequence.
Make sure that you install the drive belt on top
of the steering support plate (F) and the clutch/
brake pedal shaft (G).
Battery
To clean the battery and the terminals
Corrosion and dirt on the battery and terminals can
cause the battery to drain power.
1. Remove the terminal guard.
2. Disconnect the BLACK battery cable.
3. Disconnect the RED battery cable and remove
the battery from the product.
4. Spray the battery with water and let dry.
5. Clean the terminals and battery cable ends with
a wire brush.
6. Lubricate the terminals with grease or equivalent.
7. Install the battery. Refer to
on page 23 .
G
C
To replace the battery
2047 - 001 - 04.01.2023