Connecting The Drive Cables - Epson ActionPC 5000 User Manual

Connecting the Drive Cables

After you replace the bracket, you need to
for both the hard disk drive and the diskette drive. This section
includes steps for the following procedures:
Connecting the drive ribbon cable to the system board
Reconnecting the cables to the diskette drive.
Connecting the drive cable to the system board
Follow the steps below to connect the hard drive ribbon cable
to the system board, if it is not already connected.
1. Locate the hard disk drive ribbon cable; it is a flat cable with
a connector on each end and an additional connector on the
ribbon cable. All the connectors on this cable look the same.
system board
connector
2. Locate the hard disk drive connector on the system board.
connector for second
hard disk drive
red wire
Installing and Removing Drives
the cables
connect
connector for first
hard disk drive
5-9