Starting The Setup Program - Epson ActionPC 5000 User Manual

features for optimizing system performance
system and the hard disk drive go into low-power standby
mode.
SETUP also provides summary information about your system.
The SETUP program and the factory default options for your
computer are stored in the computer's ROM (read-only
memory). The configuration information you enter is backed
up by a battery, so it is not erased when you turn off or reset
the computer.

Starting the SETUP Program

When you start your computer, it performs some power-on
diagnostics. During these diagnostics, you may see the
following message:
Press <F2> to enter SETUP
Press F2 to run SETUP. This message is only on the screen for a
few seconds. If you missed it, restart your computer and try
again. (If you want, you can disable this message in SETUP.)
If, during power-on diagnostics, the system detects an error in
your system configuration, you hear two beeps and see an
error message followed by this message:
Press <F1> to resume, <F2> to run SETUP
Press F2 to run SETUP.
2-2 Running SETUP and Installing Drivers