Epson ActionPC 5000 User Manual page 52

If you set the Diskette Access option to Supervisor, you
can access a diskette drive only if you entered the Supervisor
password when you started your system. If you entered a User
password when you started the system but the Diskette
Access option is set to Supervisor, you see an error message
when you access the diskette drive.
When you need to enter your password, you'll see the prompt,
Enter
password:.
rectangle for each character you type. When you press
the computer loads the operating system (or starts SETUP).
If you don't enter the correct password the first time you type
it, you can try two more times. If you haven't entered the
correct password on the third try, the computer locks up to
prevent unauthorized access. You see the message:
System Disabled!
You must either turn off the computer or press the RESET
button to start over. In this situation, you cannot reset the
computer by pressing Ctrl Alt Del.
Note
If you want to delete your password, you must run the
SETUP program and follow the instructions for deleting a
password in Chapter 2.
If you do not remember your password, see "Password
Problems" in Chapter 6.
As you type your password, you see a
Enter,
using Your computer
3-7