Installing The Wireless Speaker Battery; Connecting Power To The Vcs850 - VTech VCS850 User Manual

Getting started

Installing the wireless speaker battery

• Risk of explosion! Batteries should not be exposed to excessive heat
such as bright sunlight or fire.
• Use only the supplied battery.
• Risque d'explosion! Le bloc-piles ne doit pas être exposé à la
chaleur excessive telle que la lumière du soleil ou au feu.
• N'utilisez que la pile incluse.
1. After removing the battery door, plug the battery connector securely into
the socket inside the battery compartment.
2. Place the battery into the battery compartment.
3. Attach the battery door until it clicks into place.

Connecting power to the VCS850

1. Plug one end of the AC adapter into the power jack on the bottom of the
unit.
2. Route the cord through the slots.
3. Plug the large end of the AC adapter into a wall outlet not controlled by a
switch.
After connecting power, the VCS850 LEDs light orange for five seconds.
• The supplied power adapter is designed for use with only the
VCS850. It is not designed to power other devices. Do not connect
the supplied power adapter to any other devices.
• The AC power cord is intended for a vertical or floor mount position.
The prongs are not designed to hold the plug in place if it is plugged
into a ceiling or cabinet outlet.
3