ErisStation
®
TM
SIP DECT Expansion Wireless Speakerphone
Wireless Conference System
Quick start guide
businessphones.v tec h.c om
Model: VCS850
Congratulations
on
purchasing your new VTech product.
For support, shopping, and everything new at VTech, visit
our website at businessphones.vtech.com.
The VCS850 Wireless Speakerphone extends the range
of the VCS752 SIP Conference Phone. Register up to
three VCS850 Wireless Speakerphones to continue
conversations anywhere in a large conference room.
1
5
2
6
3
4
7
Charge LED
•
On when charging
•
Off when charging is complete
•
Flashes when battery is low
1. Microphone
5. Multipurpose LEDs (four)
2. Speaker
/
6.
3. MUTE ALL
• Press to adjust the
During a call, press to
ringer volume.
mute or end mute all
microphones in the
• During a call, press
system.
to adjust the listening
volume.
4.
7. Microphone
Press to answer or end
a call.
LED color and behavior
VCS850 Status
GREEN
Steady
• Call active, speaker on
Flashing
• Incoming call
Flashing (with red LED)
• Ready for registration
Slow flash
• Paged by base
On for 5 secs
• Successfully registered
RED
Flashing (with green LED)
• Ready for registration
On for 5 secs
• Registration failed
Steady
• Microphone muted
Slow flash
• Out of range, deregistered
ORANGE
Steady
• Reset mode
On for 5 secs
• Power on
Installing the wireless speaker battery
•
Risk of explosion! Batteries should not be exposed to
excessive heat such as bright sunlight or fire.
•
Use only the supplied battery.
•
Risque d'explosion! Le bloc-piles ne doit pas être exposé à
la chaleur excessive telle que la lumière du soleil ou au feu.
•
N'utilisez que la pile incluse.
1. After removing the battery door, plug the battery connector
securely into the socket inside the battery compartment.
2. Place the battery into the battery compartment.
3. Attach the battery door until it clicks into place.
Connecting power to the VCS850
1. Plug one end of the AC adapter into the power jack on the
bottom of the unit.
2. Route the cord through the slots.
3. Plug the large end of the AC adapter into a wall outlet not
controlled by a switch.
• After connecting power, the VCS850 LEDs should flash red
and green, indicating the unit is ready for registration.
• The supplied power adapter is designed for use with only
the VCS850. It is not designed to power other devices.
Do not connect the supplied power adapter to any other
devices.
• The AC power cord is intended for a vertical or floor mount
position. The prongs are not designed to hold the plug in
place if it is plugged into a ceiling or cabinet outlet.