Maintenance; Introduction - Maintenance; Maintenance Schedule - Husqvarna AUTOMOWER 435X AWD Operator's Manual

6.1 Introduction - maintenance

WARNING:
before you do maintenance on the product.
WARNING:
For better operation and lifetime of the product, make
sure to clean the product regularly and replace worn
parts.
When the product is new, examine the blade disc and
blades each week. If the wear is low, you can increase
the interval for the next time you examine the blade
disc and blades. Examine the blade disc and the blades
more regularly if there is much wear.

6.2 Maintenance schedule

The maintenance schedule shows how to do
servicing and maintenance on the product. Follow the
maintenance schedule for a better operation and to
increase the lifetime of the product.
To prepare
Clean the product. Refer to Clean the product on page 30 .
Examine the product for damage and wear.
Do an update of the firmware.
Do a check of the servicing messages for recommended upgrades.
Servicing
Examine the blades and replace the blades and blade screws if it is necessary.
Refer to Replacement of the blades on page 31 .
Examine and polish the contact plates on the charging station.
Examine and polish the charging plates on the product.
Charge the battery fully before you put the product into storage. Refer to
charge the battery on page 28 .
Examine the wheels for wear.
Examine and clean the collision columns. Do a check of the tightening torque on
the front and rear collision columns.
Make sure that the product is docking and charging correctly.
Examine the cable and connector to the charging plates on the body of the
product.
1404 - 013 - 20.12.2022

6 Maintenance

Set the product to OFF
Use protective gloves.
It is important that the blade disc rotates easily and that
the edges of the blades are not damaged. The usual
lifetime of the blades are 3 to 6 weeks. The conditions
that follow can increase or decrease the lifetime of the
blades:
• Operation time and dimension of the work area.
• Length and thickness of the grass.
• Soil, sand and use of fertilizers.
• Objects such as cones, tools, stones and roots in
the work area.
Note:
The cut result can be unsatisfactory if the
blades are blunt. Refer to Replacement of the blades
on page 31 on how to replace the blades.
X = The instructions are given in this operator's manual.
O = The instructions are not given in this operator's
manual. Speak to your approved servicing dealer.
Weekly
X
X
X
To
Every Every
year third year
O
O
X
X
X
O
O
O
O
Maintenance - 29