To Set The Product To Off; To Charge The Battery; To Adjust The Cutting Height With Automower Access - Husqvarna AUTOMOWER 435X AWD Operator's Manual

The product stops and the cutting motor stops.

5.4 To set the product to OFF

1. Push the STOP button to stop the product.
2. Enter the PIN code if it is necessary.
3. Push the jog wheel for 3 seconds. Make sure that
the LED status indicator goes off.
Note:
If the LED indicator is on or if it flashes.
LED status indicator on page 11 .
Refer to
Note:
The product cannot be set to OFF when it
is in the charging station.

5.5 To charge the battery

When the product is new or after long-term storage, the
battery can be empty. Charge the battery before you
start the product.
1. Put the product in the charging station.
2. Put the product into the charging station until the
charging plates touch the contact plates.
28 - Operation
3. Do a check that the product charges in the display
of the product.
Note:
If the battery is empty the product must charge
for a longer period of time before the product can start.
5.6 To adjust the cutting height with
®
Automower Access
The cutting height can be adjusted from MIN (3 cm / 1.2
in.) to MAX (7 cm / 2.8 in.).
CAUTION:
The first weeks after a new
installation, set the cutting height to MAX to
prevent damage to the loop wire. You can
then lower the cutting height each week.
1. Push the STOP button to stop the product.
2. Use the jog wheel to select
3. Use the jog wheel to select the cutting height
symbol.
4. Turn the jog wheel to change the cutting height.
5. Push the jog wheel to select the cutting height.
Settings .
1404 - 013 - 20.12.2022