Symptoms - Husqvarna AUTOMOWER 435X AWD Operator's Manual

charging station is not green, follow the troubleshooting
table below.
LED indicator Cause
Constant green The signals of the charging station are good.
Flashes green The signals of the charging station are good
and
Flashes blue The boundary wire is not connected to the
charging station.
The boundary wire is damaged.
Flashes red Interference in the antenna of the charging
station.
Constant red Error in the circuit board or incorrect power
supply in the charging station.

7.6 Symptoms

If your product does not work as expected, follow the symptoms guide below.
There is a FAQ (Frequently Asked Questions) on www.husqvarna.com which provides more detailed answers to a
number of standard questions. Speak to your local Husqvarna representative if you still cannot find the reason for the
fault.
Symptoms Cause
The product has diffi- The boundary wire is not laid in a long
culty docking. straight line that is far enough out from the
charging station.
The charging station is on a slope.
The product runs at The clock needs to be set.
the wrong time.
The start and stop times for mowing are in-
correct.
The product vibrates. Damaged blades lead to imbalance in the
cutting system.
Too many blades in the same position lead
to imbalance in the cutting system.
Different versions (thickness) of Husqvarna
blades are used.
The product runs, but The product searches for the charging sta-
the blade disc does tion.
not rotate.
1404 - 013 - 20.12.2022
ECO mode is enabled.
Speak to your local Husqvarna representative or go to
www.husqvarna.com for more information.
Action
No procedure is necessary.
No procedure is necessary.
Connect the boundary wire to the charging
station.
Replace the damaged section of the boun-
dary wire with new boundary wire.
Speak to your local Husqvarna representa-
tive.
The error must be corrected by an authorized
service technician. Speak to your local Husq-
varna representative.
Action
Check that the charging station has been in-
stalled according to the instructions. Refer to
To install the charging station on page 17
Place the charging station on a surface that
is entirely level. Refer to
to put the charging station on page 12 .
Set the clock. Refer to
25 .
Reset the start time and change the
ule settings. Refer to Schedule on page 23 .
Inspect the blades and screws and replace
them if necessary. Refer to
the blades on page 31 .
Check that only one blade is fitted at each
screw.
Check if the blades are of different versions.
No action. The blade disc does not rotate
when the product is searching for the charg-
ing station.
To examine where
Time & date on page
Sched-
Replacement of
Troubleshooting - 45