Operation - Dometic NDS IM12-150 Installation And Operating Manual

No. Component
1 Display (optional)
2 Control unit
3 Wireless display (optional)
4 Charge controller
5 Solar panel
6 Solar panel
7 Battery charger
8 Inverter
9 House battery 1
10 House battery 2
11 Additional 12 V devices
12 12 V fridge or oven
13 Split-charge relay
14 Starting battery
15 Alternator

8 Operation

NOTICE! Damage hazard
• Do not touch the display with hard or sharp objects. Touch the display with your fingertips.
• Do not apply strong pressure to the display.
• Avoid contact with other electronic devices to avoid generating static discharges.
Note
• Do not touch the display with wet fingers or similar.
• Immediately after installation, the displayed state of charge may be incorrect. After the first use of
the battery this will be corrected automatically by the battery monitor.
Switching the battery monitor on/off
Note The display and the control unit are always switched on or off at the same time.
To switch the battery monitor on, proceed as follows:
Use the on/off button on the control unit (6,
Tap on the display.
Connect a charging source to the battery monitor.
To switch the battery monitor off, proceed as follows:
Use the on/off switch on the control unit (6,
fig.  on page 10).
fig.  on page 10).
EN
23