Operation - Dometic Mini Heki S FL Installation And Operating Manual

Mini Heki S FL
See fig. 7
A
NOTICE! Damage hazard
Observe the instructions of the sealant manufacturer.
➤ Seal the mounting frame with a flexible non-hardening sealing compound (e.g.,
SikaLastomer-710).
See fig. 8
1. Observe the direction of travel when installing.
2. Place the outer frame in the middle of the roof opening.
See fig. 9
1. Install the mounting frame.
2. Tighten the screws and re-tight them 10 minutes after installation.
See fig. 0
➤ Fit the inner frame into the mounting frame.
See fig. a
1. Push the inner frame onto the mounting frame.
2. After installing, check the roof light works properly.
3. Remove the protective film from the acrylic glass.
I
NOTE
If the protective film is exposed to sunlight for too long, it cannot be
taken off without leaving a residue.
4. If necessary, enter the new vehicle height and weight in the vehicle documents.
7

Operation

7.1 Opening and closing Mini Heki S FL
➤ Open and close the roof light as shown (fig. b to fig. d).
EN
Operation
7