New Holland 300 Series Service Manual page 36

7. Slowly raise the loader arm until the support strut (B)
falls onto the cylinder rod (D).
8. Stop the engine.
9. Pull up on the override control knob (E) (red control
knob near the right-hand side of the operator's seat).
The support strut (B) will brace against the top of the
cylinder barrel (C) supporting the weight of the loader
arm.
NOTICE: Only use the override control knob for emer-
gency situations where engine power is not available or
to lock the loader arm on to the support strut for servicing
the machine.
10. Ask an assistant to insert the pin (A) into the support
strut (B). If an assistant is not available visually con-
firm that the support strut is braced against the top of
the cylinder barrel before exiting the machine.
Tilt and lock the cab forward for machine service
1. Remove the two, rear retaining nuts, located at the
rear of the cab.
INTRODUCTION
51517858 10/11/2020
29
3
RAIL14SSL0418AA
4
93107465A
5
93106854A
6
931001633