Safety Rules - Specific To This Machine - New Holland 300 Series Service Manual

Safety rules - Specific to this machine

DANGER
Crushing hazard!
Do not enter or exit the operator's compartment while the loader arms are raised or unsupported. Rest
the loader arms on the ground or verify that loader arm is being supported by the loader arm strut or
loader arm lock pin before entering or exiting the operator's compartment.
Failure to comply will result in death or serious injury.
Specific precautions to this machine:
• All machines are equipped with safety support features when service or maintenance of the machine is required.
You may secure the loader arm in a raised position and secure the cab in a tilt position. These features allow
greater access to the internal components of the machine. Read and understand the "Loader arm lock and cab tilt
procedure - vertical lift machines" page Basic instructions - Loader arm lock and cab tilt procedure - radial lift
machines () or "Loader arm lock and cab tilt procedure - vertical lift machines" page Basic instructions - Loader
arm lock and cab tilt procedure - vertical lift machines () in this manual.
• Place all controls in neutral before leaving the cab and be careful not to engage them accidently when entering or
exiting the cab.
• Before leaving the operators compartment check the interlock system so movement of controls do not result in ma-
chine movement. Follow the "Joystick and Electro-Hydraulic (EH) control - Check loader arm and bucket hydraulic
interlock" procedure on page Joystick and Electro-Hydraulic (EH) control - Check loader arm and bucket hy-
draulic interlock (55.512).
• Keep the load or tool as low as possible while moving the machine around the job site.
• Confirm that the coupler lock pins are engaged with the bucket or attachment retaining tabs.
• Do not over fill the bucket. Dirt, rocks, and debris can enter the operator area.
INTRODUCTION
51517858 10/11/2020
12
D0168A