Removing The Main Tray Assembly - HP C160 Owner's Manual

Changing Your Workstation's Hardware Configuration

Removing the Main Tray Assembly

Removing the Main Tray Assembly
Perform the following steps to remove the main tray assembly:
1 Power off the system, the monitor, and any peripheral devices. Unplug the system
NOTICE: There is no need to manually shut down the HP-UX operating system on
your workstation before powering it off. When you turn off the power
switch, your workstation automatically shuts down the operating system
before terminating the power.
2 Disconnect cables from any peripheral devices.
3 Attach a static-grounding wrist strap to bare metal on the back panel of the system
4 Completely loosen the five thumb screws on the rear of the system unit, as shown
Thumb Screws
Figure 38
122
unit power cord and the power cord of any peripheral devices from ac wall out-
lets. Disconnect the power cord from the system unit.
unit.
in Figure 38.
Removing Main Tray Assembly
Thumb
Screws