B Changing Your Workstation's Hardware Configuration - HP C160 Owner's Manual

Changing Your Workstation's Hardware Configuration
This appendix describes the procedures to change your workstation's hard-
ware configuration. It presents the information in the following sections:
•
•
•
•
•
•
•
•
•
NOTICE: Your workstation shipped with a package of extra disk slides. Keep the
slides in a safe place, you will need them when you add new devices to the
storage tray.
CAUTION: Always wear a properly grounded wrist strap when reconfiguring your
workstation.
Use the following tools to remove or replace hardware parts when changing
your configuration:
•
•
Also, read the ESD Precautions in Appendix A of this guide.
100
Checking the SCSI IDs
Preparing your workstation
Installing storage devices
Removing the main tray assembly
Replacing the main tray assembly
Installing additional memory
Installing the EGRAM module
Installing an EISA, PCI, or GSC option board
Changing your monitor type
Light-duty flatblade screwdriver with 150 mm (6 inch) blade
Needlenose pliers