Installing A Hard Disk Drive In Position 3 Or Position 4 - HP C160 Owner's Manual

Installing a Hard Disk Drive in Position 3 or Position 4

Perform the following procedure to install a hard disk drive in positions 3 or
4 of the storage tray:
1 Remove the two retaining screws from the disk interconnect board, as shown in
2 Remove the fan bracket and disconnect the fan cable.
Figure 34
3 Disconnect any cables from the disk interconnect board.
4 Hold the disk interconnect board on the edges and lift it straight up to remove it,
Figure 34.
Removing the Disk Interconnect Board
as shown in Figure 34.
Changing Your Workstation's Hardware Configuration
Installing Storage Devices
115