Table of Contents
Advertisement
Returning the Device to Factory Default Settings
If you want to return the ISG 2000 to its default settings, you can do either of the
following, depending on whether or not your are logged in:
By default the device recovery feature is enabled. You can disable it by entering
NOTE:
the following CLI command: unset admin device-reset
If you are logged in, you can enter the following sequence of commands:
unset all
The following prompt appears: "Erase all system config, are you sure y / [n]?"
Press the Y key.
The system configuration is returned to the factory default settings.
reset
The following prompt appears: "Configuration modified, save? [y] / n"
Press the N key.
The following prompt appears: "System reset, are you sure? y / [n] n"
Press the Y key.
The system reboots.
If you lose your admin name or password, you can use the following procedure
to reset the NetScreen device to its default settings. This destroys any existing
configurations but restores access to the device. To perform this operation, you
need to make a console connection, as described in "Console Connection and
Login" on page 3.
1. At the login prompt, type the serial number of the device.
2. At the password prompt, type the serial number again.
The following message appears:
!!! Lost Password Reset !!! You have initiated a command to reset the
device to factory defaults, clearing all current configuration and
settings. Would you like to continue? y/[n]
3. Press the Y key.
The following message appears:
!! Reconfirm Lost Password Reset !! If you continue, the entire
configuration of the device will be erased. In addition, a permanent
counter will be incremented to signify that this device has been reset.
This is your last chance to cancel this command. If you proceed, the
device will return to factory default configuration, which is: System IP:
192.168.1.1; username: netscreen; password: netscreen. Would you
like to continue? y/[n]
4. Press the Y key to reset the device.
You can now log in using netscreen as the default admin name and
password.
Chapter 1: Configuring
Returning the Device to Factory Default Settings
21
Advertisement
Table of Contents
