Configuring - Juniper ISG 2000 User Manual

Chapter 1

Configuring

NOTE:
NOTE:
This chapter describes how to make a console connection to the ISG 2000, log in,
and perform a basic configuration.
Table 1: Important Default Configuration Settings
Default MGT IP address: 192.168.1.1/24
Default ethernet IP addresses: 0.0.0.0/0
Default username: netscreen
Default password: netscreen
You must register your product at
activate specific services, such as Intrusion Detection and Prevention (IDP).
After registering your product, purchase a license key from your value added
reseller (VAR), and then use NetScreen-Security Manager, the WebUI, or
the CLI to load the key. For information about registering your product and
obtaining and loading license keys, see the Fundamentals volume in the
NetScreen Concepts & Examples ScreenOS Reference Guide on the documentation
CD that ships with the ISG 2000.
This chapter includes the following main configuration sections:
"Before Beginning" on page 2
"Console Connection and Login" on page 3
"Basic Configuration" on page 4
"System Clock and Console Timeout" on page 5
"Admin Name and Password" on page 5
"Security Zones and Interfaces" on page 6
"DNS and Default Route" on page 12
"Policies" on page 13
"Intrusion Detection and Protection" on page 15
"IPSec VPN" on page 16
"Summary of CLI Commands" on page 19
"Returning the Device to Factory Default Settings" on page 21
For information on different configuration options such as virtual systems and
high availability, see the NetScreen Concepts & Examples ScreenOS Reference Guide.
www.juniper.net/support/
so that you can
1